Recent content by chriswood6725

Thanks for all replies, I have so far ordered up the following: New ignition switch - sounds fairly easy to change over, although never done it before Timer relay from a disco - will wire up in same manor as intended, so the dash light will go out when ready Replacement wiring to link plugs -...

Morning all, I recently did a 300tdi conversion from a 2.5na, all went well as I connected a single glowplug to the original brown cable (used on the 2.5na) Anyway, its been chugging when started from cold with a bit of smoke - so thought id connect up the other glow plugs and see if it got...

Thanks for the advice, I originally thought I had dropped a needle roller but have now confirmed the rear prop is a different bearing size to the front Fronts - 82mm Rears - 75mm So a prop has been changed over the years - I shouldn't have been so presumptuous in the first place I guess... Chris

Hi All, Ive bought a full set of UJ's for each prop, I bought GKN products (so no cheap rubbish) Front is fully rebuilt but the rear is a different matter... Although they press in, they appear too long as (is flush with the outside of the housing and no chance of getting the clip in I didn't...

Or can I squirt one shot grease after all the oil has dripped out (most of it has). Seems to be quite a popular temp fix?

Afternoon all, My steering box is leaking fluid all over the place (Non PAS), I figure instead of repair I could upgrade.. Will a setup from a 200tdi Disco be a straight swap or is the pump completely different? Im running the original 2.5td 19j engine (dont laugh) Thanks Chris

Just having a poke around online and it appears the "F" suffix was the first year of production to have the cross drilled input (helps me date it anyway,around 1995) http://www.landroveraddict.com/forums/thread.cfm?threadID=55023 Many thanks

Yeah I've just had a look, the website describes how to check (first two numbers and last letter) - this makes mine a 28F.. There is no mention of that kind anywhere??

Hi All, I have the following serial number from a Disco Transfer Box - 28D470632F I've searched around and it seems it will go straight onto my LT77 gearobx, but I was hoping to identify its age from the serial number - has anyone got an ideas? The speedo connector looks a bit different but...

Hi all, done most jobs on the landy but never the rear hubs... Anyway I topped up the rear diff last night, and after a drive this morning I notice both hubs are leaking oil onto the wheels - assume it's not much of a job to replace the seals?? More concerning is, I noticed what appears to...

Anyone know? Cheers

Hi all, I have a 1986 landrover 90 and I need to fit a towbar. o Does anyone knowing they're all the same or did they change at td5 etc? Thanks

I've got a decent set of 265 / 70 / 16 Recip Mud terrains that are less aggressive - im looking for more aggression! Cheers

I hadn't fully tightened the two bolts down and didn't realise it would "lift" the hub and lower taper bearing into place All appears well even though I feel a bit stupid... Thanks for your help though :)

Please ignore, I was being a dohnut...