Recent content by booboodag

Have seen this a few times on the TD4, if you can manage to drive it, even though its a pig to change gear just preserver with it, it will be air in the system. Have know them after a few days to get better as the air raises. It could be worth just trying it before you start to explore other...

When you unlock the car is it then that the window comes down. As holding the unlock button on the fob in normal operation for 5 seconds make the window drop. Could it be the button on the fob sticking.

Some of us are a little more forgiving to newbies. Unfortunately there are a number of things that it could be, but with the light on would look at a fuel issue. Can you hear the low pressure pump in the driver side rear wheel arch running with the ignition on. If so then lift bonnet and have a...

Hi Andy, stupid question but how it going. Wish I had seen your post earlier as have a spare pump kicking around that you could have tried. Not come across your problem but must be a bit out of the fuel filter?. Give me a shout next time if you still have my number if you need any parts as...

Whilst it does sound like a faulty sensor, I know you say the brake lights work ok, for the cost of one I would change the brake light switch. Once came across a similar problem brake lights worked ok, but three amigos were on, changed switch and bingo,

When they changed the fuel filter to the rear wheel arch, they also went to a single pump. If you do decide to change the pump then go for a OEM pump as some of the cheap pumps around have had bad reviews.

You will find it is in the drivers side rear wheel arch, its a bit of a pig to do. Its easier to remove the entire cradle and fit filter on the bench. The filter was changed to wheel arch on 2002/2003

The other thing it can be is wear on the cables. as it only drops a small amount when opening the tailgate, the motor and pulleys move the correct amount but the cables need to take up the slack due to the wear and the glass only move half the amount.

Been following this with interest, it does sound like to much travel on a front calliper or wheel cylinder, or still air in the system are the back shoes adjusted ok ?. What I would do is clamp all the flexi hoses off and see if you get a pedal with engine on if so release one at a time and re...

Don't worry about it they all do it, if you ever need to run engine with cover off just refit bolt.

was it the side from the lower picture that has caused the problems? as that's the one with the spring correctly located.

Hope that the spring is the cause of you issues, but which ever position the spring is fastened to it still just gives downwards pressure. The main issues are normal the arm, the hand brake cable fastens to. They don't pivot freely due age last one I did took a good hour to totally free. If the...

I have seen it once, when pushing the pistons back it damaged the seals in master cylinder, all we did was replace master and all back to normal. crack the pipes on master cylinder and see if you get fluid out.

Thanks for the info, I did think about that, however the prop is off and I can not get any unusual movement in any direction. It does appear to be from the rear and more like a tyre out of balance however now the prop is off its fine. Did think about the IRD but its only a vibration no...

Should there be any play in a rear diff, was getting a vibration that was getting worse. With the rear end off the floor, I can get about 10deg of movement in the wheel till it starts to move the output shaft to the prop. I am assuming that the pinion and crown wheel should be fully meshed...