If anyone says put the rubber seal on the pump first tell em to do one. Put the seal on the tank then just push the pump through and your locking ring will go on easy.
All sorted now till the next time
Update I've just put a new fuel pump in and now its running fie,but can i hell as like get that locking ring on? any tips.
and thanks for all your replies
Thanks for the reply fella's. I've just removed the carpet then started to whack the ring round holding the pump in and it started whirring, left it 30 secs and it stopped again.there is power going to the plug i checked that,so what do you think dodgy pump? thanks
I forgot to add this was running absolutely fine until the Mrs used it one day and she didn't wait for the glow plug light to go outdent know if that could have done anything to it.
Another same old post.
2001 disco no power will not go over 2500 revs,judders like mad. I've checked the injector harness and its clean no oil but i replaced it anyway "no difference". removed the MAF sensor "no difference"
I cannot hear the fuel pump running though at all? but it still runs...
It's just 2 torn bit screws that hold the centre of steering wheel on.and when you remove it you will see your airbag with a yellow wire going to it.i took mine off last week to straighten the steering wheel.but I was very careful of the yellow wire because someone once said if u cut it or...
I've just removed my egr valve and fitted a blanking kit and what a difference.
No black smoke and it pulls a lot more quicker than it ever did before.
Real easy as well.:)
Hi mate them seals are actually just finishing strips and they are normally bonded on when the windscreen is fitted.if you get it off without breaking the glass it will be knackered anyway because there is metal in that trim that bends up on removal.
Tbh I would leave it.