Recent content by antdawe

Just took my freelander out and it sounds terribly tinney. It wont go over 50mph, foot flat to the floor. Help Any suggestions its just incurred a serious loss of power. struggling to pull up the hill.

Where is the best most common place to put a cd changer in a 3 door freelander

Is this possible or not. Lots of people have upgraded their exterior freelander to the face lift model. Has any one actually done the interior aswell?

think its abs - discs on front and drums on back. how do i tell

abs. do i need to know anything. this howling noise im refering to does stop when i apply the breaks. does thi mean a bearing or brakes?

what i have said on previous post is that the wheel doesnt spin. itgoes forward about 6 inches then stops. would this make sense if the brake was sligtly stuck on?

funny you should say the one brake pad is metal to metal. gonna change tem tomorrow. never had a freelander before but what i have noticed is that if im on the motorway and put the clucth down it slows very quickly. this prob corrosponds with what you are saying regarding a brake stuck on.

enough of the junk. i asked a serious question please give me a serious answer. yes, its a howling noise very loud.

done the tests and thank god they are not lined up when i re checked. also put one back wheel in mud and it spun on its wn until the tc corrected it. I still need some serious help on this loud houling sound when i go over 60mph on any kind of upward road.

Theres a loud howling noise coming from my freelander 1.8i when i go about 60mph uphill. the front o/s wheel get red hot? is this a bearing and is this related to the howling sound? its a very very loud howling sound.

should the front wheel spin easily when jacked up. only reason i think its the vcu is because of this front wheel not spinning and there is a very loud houling sound when going over 60mph on a light up hill

Lots of posts on here about the tippex test. I am a newbie and really dont know where to mark. could someone do a diagram or something. i did it and put a line through the two hubs that turn but i didnt mark the shafts. Where EXACTLY should i be marking. Thanks

The vcu does spin but both hubs spin together at the same speed.

I have attatched a pic which is the best way i can describe it. I put a line of tippex through the large one to the smaller one in line with the prop shaft.

I took it to a specialist today and they told me to do the visous test. i put tippex in a line and it was still lined up after i drove it full lock. does this mean that the viscous is f***ed. the specialist said this would stop the front wheel from free turning on its own.