Window frame removal

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
archwayanimal

archwayanimal

Active Member
Posts
191
Location
Oxfordshire
I need to remove the driver's side window frame on my D2 to replace the channel run. Can I do so without removing the actual glass, if I am careful? Assume the frame once the bolts have been removed will just slide out over the glass, and I then can slide back after fitting new channel run...?

TVM
 
thank you - I had found this excellent post but don't want to take the glass out if I don't have to. Just wondered if anyone had taken the window frame out but left the glass in place...
 
I don't see that there is any way to do that? I recently changed one of mine and it was just part of the process. I can't see why you wouldn't want to remove the glass - just gaffa tape it to the frame, undo the two bolts from the regulator and lift frame and glass out as one unit. Then fit glass to new frame and drop it back in.

Cheers!
 
So I took the window frame and glass out, fitted new channel run and put all back together. The when reattaching glass I noticed one of the white nylon wheels had shattered and now the window goes up ok but there is a bang and a wobble before it comes down. Also one of the x arms is a bit bent now. Can you replace that wheel or do you have to replace the whole unit?
 
You must log in or register to reply here.

Similar threads

R
Window lift channel - changeover year joy!
Replies
2
Views
563
Mark Piercy
Mark Piercy
Grrrrrr
P38A Seized nuts!
Replies
6
Views
361
Grrrrrr
Grrrrrr
Rubberknees
P38 rear door window trims replacement
Replies
14
Views
3K
Rubberknees
Rubberknees
P
Defender 90 - 1987 - leaky sunroof
Replies
7
Views
2K
Anaconda
A
T
A frame bushes
Replies
13
Views
1K
Anaconda
A
Back
Top