Where is the cruise control vacume pump?
- Thread starter ben 84
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
discool
Well-Known Member
- Posts
- 13,627
Under where the jack is or would be positioned u can see a bit of it in one of the two large round holes that are there.
drewster
Well-Known Member
- Posts
- 2,997
- Location
- new milton hampshire
under the batt tray on a 300
drewster
Well-Known Member
- Posts
- 2,997
- Location
- new milton hampshire
sorry got it wrong it is under the air box /jack might be a bugger to get to just looked throcgh my old manual
discool
Well-Known Member
- Posts
- 13,627
Your not wrong there I used a mirror on a stick thing to see what was what (top tip) then refitted the hose by feel then went and got the plasters to cover the scratches on the back of my hand.
mjltigger
New Member
- Posts
- 1,890
- Location
- Trowbridge, Wiltshire...
it's held in by two (or three??) rubber mounts that you can see from underneath.. push them through and it will come out through the hole to the right of the one you can see it through (closer to the middle of the engine bay) I believe these holes come out of the factory covered in a rubber sheet so you may not be able to see them but the sheet is just held down by mastck or similar.. you can also test the pump once it's out by wiring directly to the battery +ve then earthing the other two pins.. if it's all working it will pull the throttle fully open then release when you disconnect.
