Wheels won't fit.

Hi all,
I have searched for an answer to this but no joy.
I have just bought some hawke 22in wheels that were on a 2014 range rover sport. After looking around to check they would fit everything seemed to point towards the fact they would and i would just need some new lugs. I have just offered them up and the won't fit on the hub. Any thoughts out there? Are my discs wrong?
Many thanks in advance

JamieRR said:

I have just bought some hawke 22in wheels that were on a 2014 range rover sport.

Click to expand...

Might help if you say what you are trying to fit them too.

Cheers

Ah yes! Sorry. It's a 2002 l322 vogue.
My bad.

I wouldn't be at all surprised that they don't fit.
Discovery 1 wheels don't have the same stud pattern as the Discovery 2, but the wheels off a P38 will fit on a Disco 2.
So, go figure.
Other than that, I'm sorry but I can't help.

https://www.wheel-size.com/size/land-rover/range-rover-sport/2014/

https://www.wheel-size.com/size/land-rover/range-rover/2002/

Looking at this, it would appear they are similar, so what is causing the hangup?

Cheers

The hub seems to be a few mm too big. It will just go on the hub but not all the way. The studs all match up and I've tried to push on with my feet. It just seems strange to be only a few mm off.

Judging by the two pages noted by @neilly, the centre bore should be the same at 72.6 mm. The fit there shouldn't be a very tight fit, but it shouldn't be wobbly either, it's done like that to reduce vibration should the wheel run slightly off centre. Check that there's not a build-up of crud around the centre of the hub and the inside edge of the centre hole of the wheels.
The only size I could see with a difference was the offset, the ET number, could something behind the wheel be fouling when you're trying to fit it?

Thanks for the replies chaps.
I've given them a rub down and checked for any abnormalities but still no joy.
I think I'll leave it till the weekend and get some extra muscle to help.
Think I've had enough range rover for today.
Cheers

JamieRR said:

Hi all,
I have searched for an answer to this but no joy.
I have just bought some hawke 22in wheels that were on a 2014 range rover sport. After looking around to check they would fit everything seemed to point towards the fact they would and i would just need some new lugs. I have just offered them up and the won't fit on the hub. Any thoughts out there? Are my discs wrong?
Many thanks in advance

Click to expand...

They don't fit the studs? Sounds like you have a different pcd

Re read. Sounds like you need spigot rings