What is this part?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
A

alarge

New Member
Posts
4
Hi

With all this talk of snow, have decided it's time to repair my parents crash damaged Disco. It was only a light front near side collision with a wall. I have found most parts online, such as inner wing, bumper support bar etc. However i'm at a loss as to what panel / part I need here...

discofrontpart.jpg


I have tried searching on the internet etc but to no avail.

Thanks

Andrew
 
check out LRO International magazine, they are doing a rebuild project on a crash damaged Disco 1. it probably has all the part numbers you need, including the above item! :D
 
Been reading a copy of LRO Int. my only problem is I get carried away and think of all the things I could do! If only it was mine then that would be fine, however its not! :(

Thank you arienol, I emailed the guy yesterday asking if it would fit a 300 series and he wasn't sure. Does anyone know if the 200 series bulkhead differs to the 300? If so is it much of an issue to fit?

Thanks again guys!

Andrew
 
how perfect does it need to be, i repaired mine - it's held together with spot welds which are easy to drill out, all you need to do is bash it back into shape and weld it back together, much quicker than stripping it out.
 
I'd quite like to do a good job on it. I had a ding in the front on my car once and the front bulkhead / landing panel was badly twisted. I smacked it out as best I could, but I can still see it's there and it bugs me. For the sake of £50 and messing about stripping, bashing etc, I'd rather swap the whole lot out tbh. That assumes that it would be a straight / relatively easy fit, otherwise it may well be hammer time!
 
Yeah it's worth changing if you want it right.

Mine a bit bent I think somewhere cos I hit a tree once.

All is fine apart from the grill is closer to the bonnet on the drivers side. And yes I've tried jumping up and down on it and that sort of thing but can't seem to align it better without bending something else. So it's staying as it is now.

Cheers :)
 
You must log in or register to reply here.

Similar threads

S
Disco 1 Disco 1 Rust repair prep
2
Replies
20
Views
2K
sv_dOnut
S
ChrisBduck
3.6L Land rover 90
Replies
2
Views
973
ChrisBduck
ChrisBduck
K
What money should I be asking?
2
Replies
27
Views
4K
Karls
K
Blob
L322 Solved - C1A13-64 (AF) Pressure does not decrease when venting gallery
Replies
2
Views
3K
stuu
stuu
Goc3k
Discovery 1 SOLD 1997 300TDI manual D1, Winchester
Replies
16
Views
4K
Goc3k
Goc3k
Back
Top