What have you done to your Landie today.

robint said:

lieing bastid so hwo did all they cones get in me garage then

Click to expand...

Ermm well ermm No comment officer..

prepping the Glandy for a Night run

on the GAP ROAD !!!!!!!!!!!!!!

any one interested in joining us, fell free ..............

Making good the loom that runs through the chassis on the Series. Solder, heatshrink an' all that.... looks like plenty of heat damage due previous welding but all good now.

fitted my 3" eggsause system which exits through side in front of nsr wheel, fitted new filler neck and locking cap and wired up coil and some other bits

took jnr to the tank museum in me series...nearly broke down on the way back due to fuel starvation.....limped home then emptied out the little glass jar on the pump,now seems to be running ok

Replaced burst heater inlet hose.

howardo said:

Replaced burst heater inlet hose.

Click to expand...

see i told you the hippo's are crap howardo.:behindsofa::bolt:

snigger

It was the original hose and has done over 127000 miles. It had just perished.
Easy fix.

howardo said:

It was the original hose and has done over 127000 miles. It had just perished.

Click to expand...

perish the thought that it could fail.

roof and sides off, gearbox out , going to see why reverse and 3rd make so much noise

Used it to recover four scrap Anzarni Iron Horses out of an orchard and take then away after loading them into a trailer with an engine crane. Knackered now, it took thre of us.

tuk her fa MOT n she failed!

jimbot90 said:

tuk her fa MOT n she failed!

Click to expand...

awwwe bad luck mate, mines next week, what she fail on.

Took a nackered old motorbike to Nottingham and came back with a mig welder and a small petrol generator, straight swap! Now I need to learn to mig weld ...

Broke down on M5 with suspension on bump stops



Fixed it wiv lappytop and then drove 200 miles home!!!





Fookin' p38's

took out old transfer and gear box and fitted new (well second hand one) just gotta put props back on an rivet the rubber back on top of the box and put the consol back in, oh an fill the boxes up with oil, oh and test drive it down a few nice lanes just to make sure diff lock an low range work

landowner said:

awwwe bad luck mate, mines next week, what she fail on.

Click to expand...

few bulbs,track rod end n some weldin.

moving house with mine tomorrow

Wavey87 said:

moving house with mine tomorrow

Click to expand...

Hope yer rear cross member and tow ball is up to it!