What have you done to your Landie today.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
well it must be a tough door mate, thought a stuot chap like you would of made slight impact on it:rolleyes:

have ya tried the lump hammer yet?
don't try it tonight though mate as it might not look prety in the mornin:rolleyes:

don't worry too much mate! you'll sort it soon:D
 
Yesterday changed both eggsauce marigolds with lovely new gaskets, changed the maf and replaced the air box for one off an oil burner with the intake in the wing..

Guess what fellas.. she sounds sweeeeeeeeeeeeeeeeeeeeeeet....

Not test driven yet as by the time I finished dads bbq was ready to. Eat and then I got a little bit tipsy lol...
 
fitted the radiator and intercooler from the other one into mine, went out for a couple of hours with the wife, then wired the spot lights in on the roof bar
 
Fitted winch bumper
015.jpg

016.jpg

just got to get the winch now
 
today I are mostly made some huge jackable tree sliding rock sliding side steps for the p38, and got the rear springs off the series three and found a small rustworm nest in the bottom of the series ones bulkhead. Good day and bad day but too hot to do any more
 
ha! I will do my best, I am far from the worlds most computer literate person! I'll have to talk to it nicely! Theres not enough moving parts for me to understand how it works and therefor I fear it! Witchcraft
 
packed up gear into it ready for wales tomorrow, oh and reshaped b-pillar with big hammer after its little lie down on last welsh outing, kids can shut door now!
 
Turned it over to stop the battery going flat and booked some time off next week to mot it and that.And go fishing.
 
fitted a new ABS pump relay in the hope it fixes me brake problem, then noticed i got a leak somewhere an its makin the headlinin wet above the windscreen:doh: does it ever end??
 
I tried to undo the bolts that hold the tree sliders in place..
the front one is alright as you have access through the floor, but the rear one I can't even see the top nut!

so... gave up!
 
Back
Top