What have you done to your Landie today.

Welded mounts on to the chassis for my heavy duty rear bumper, straightened ally plating on rear quarter, changed plastic cover on dials, fitted new injector seals, injector harness and rocker cover gasket. Changed fuel filter and gauze on pressure regulator. Next up today is full t-cut to remove overspray where previous owner sprayed roof black without masking correctly :-(

Checked all my wheel bearings, and took a diff oil sample, but couldn't get my transfer box fill plug out so didn't check that. Will get it on a ramp next week and do that one!

replaced the throttle cable it took all of 5 minutes

Fitted New clutch, new flywheel seal at last, putting the begger back together now.

I have also found that copious amounts of jd, newcastle brown and vodka make fitting a new clutch so much less of a chore mr p dude, thanks fer yer help today bro.

Wow.. what a day, started out by relocating my winch solenoid which went OK, moved on to attaching the front outriggers for the roll cage.. did my welder want to play ball, NO! what a PITA!

On midgets I dropped the leaf spring on driver side to refit the shackle plate as the last owner had out it on upside down and sideways! its now ready for mot

Dropped a few of my mates off so they could go out on the ****, love the looks I get when I drive through town

shoved some swivel grease in n changed rear light bulb (also put my back wheel in the r1 n changed back brake pads but i digress!)

a2dds said:

i have to ask, how did you sleep in the back of a 90?? often wonderd about doing it in mine, I know im short, but not that short haha. Plus with me tool kit in there and bits, it may be a bit hard underneath

Click to expand...

slept in her all weekend at bmf rally last week, wasnt too bad, sussed out if a move slightly diagonally i can actually stretch out corner to corner!! was more comfortable the second night, decided when i do it again, even with the tent attached to the back needs the back windows covering to cut the light out

Pressure washed chassis, to reveal what I have to grind/weld paint... :-/

Fitted a snorkle yesterday, did the ole clipboard test and it works! Very pleased with myself!

Looks the part too.

good progress for once, the cage is now refitted after spraying it, drilled all holes a little larger and bolted in using M10's instead of 8's

bulkhead fitted along with B pillars, shimed n adjusted and the gaps are all good, all measure the same as the 109" which is good as they are series doors going on

trial fitted the sliders, they still need spraying the correct yellow as the powder coat yellow is too warm....

finally sprayed the roof gal'd fittings to match the motor and finished off by jetwashing the 300tdi and r380 i collected yesterday to go in it







cheers steve

Used it to winch out a willow tree that had grown horizontally, made very light work of it

Broken it

craigyb said:

Broken it

Click to expand...

How come?

Stripped off the front wings to reveal a pair of knackered footwells to go with the chassis

STABBED THE HELL OUT OF THE DASH BOARD WITH A SCREW DRIVER!!! better than stabbing the hell out of the previous owner for making a mash of the audio wiring loom grrrrr

*minty* said:

How come?

Click to expand...

Pay and play day

NSF track rod end, adjusted 2x wheel bearings, replaced transfer box rear seal cleaned handbrake shoes and drum!