What have you done to your Landie today.

first time i have tried to put up pics . how do you do it ?

wickford90 said:

first time i have tried to put up pics . how do you do it ?

Click to expand...

http://www.landyzone.co.uk/lz/f38/picture-posting-dummies-47795.html

made up and fitted rear window trim sides and wheel boxs . cost about 30 quid all in .

wickford90 said:

made up and fitted rear window trim sides and wheel boxs . cost about 30 quid all in .

Click to expand...

Looking good.

What did ye make them out of?

made a template out of card board, transfered it and cut it out of 4mm ply, bought a 8x4 sheet fibre board and cut same. stuck the two together with impact adhesive. cut and stuck 1/4 inch foam around window so when i glued the board on , as you pushed, it compressed the foam at high spots that way it stuck all over. bought a remnant from local car trimmers stuck it on using impact adhesive ( carpet fitters contact spray in a can, not ordinary spray glue this is not up to it and goes manky )then sprayed the back of the board and the foam and carefully put it in place.same for all the other bits.

I think I've successfully replaced my lift pump.

Well, it started and didn't squirt any fuel or oil - better than before so far



Just not sure how tight I should have tightened the bolts.

Manual gave a torque setting (25Nm) but there's no way I could get my torque wrench anywhere near. In fact because it was so fiddly I ended up using a screwdriver handle with an extension and then my socket......

i cut the back of mine then welded it back in but 17" shorter than before

cleaned up all the fuses and connections and got the heater working for the first time!
Also got low fuel warning light working - lifted floor and it was unplugged from sensor. Hope all jobs are going to be this easy!

got her welded and wax oiled !!!

Ran over a rabbit (no not intentional ... I ain't BoB), it got it's revenge when one of it's bones punctured the tyre, chance in a fckin million as it's gone straight through the tread into the tyre:doh: ... crossed finger's that the tyre ain't knackered as there's lot's of tread left on it.

Changed the oil seal in my transfer box.

Thanks to Trewys thread from years ago for pointers

Got the punctured tyre repaired and had a small hole welded up (not the tyre).

Removed the steering box and front axle from my scrap Disco 1.
Also drained a couple of gallons of diesel out of it which was a bonous

Might fit the steering box on the 110 if that one's leaking. Wasn't dripping if I remember so maybe keep it for a spare.

changed fuel filter & made mounts for me awning

destroy destroy!! haha i see you wire, your mine!

Fitted a 200tdi into my bros Landy - will finnish off tomorrow , then Ill do the same with mine

painted my bonnet and boot in a stupidly bright green colour

Lent it to my son who is moving house. He just rang to say he is too knackered to bring it back until tomorrow.

Broken it again

Turned off the motorway and lost all power steering. Hopefully just the belt slipping, new one on it's way and then we'll see !!