What have you done to your Landie today.

lcbandit said:

I've done bugger all cos I've gone n fractured my ankle!! But fingers crossed landy will be ready this weekend to go for mot then back on the road will post pics when all done

Click to expand...

Unlucky ankle fractured and an MOT.... I feel for you mate!

replaced the old fooked drivers door with a better one.While I was at it the top fell apart and the same piece of glass that broke on the other side smashed Bit the bullet and ordered a new one from paddocks

Put on the new matching alloy wheel and Goodyear Wrangler tyre on the rear door, now I need to buy a set of locking wheel nuts before some scum, lower human race **** steals it!

Found out that my 200tdi will have to come out so as I can fit rings an shells

you can fit rings and shells in situ. just make sure the bay and front axle etc is clean first.

Read the thread on vehicle security...

Thought about my Defender...

THEN PANICKED!

I'm off to fit the roof lights

Well, yesterday, removed EGR valve and fitted the bypass kit

Got a new bumper ready to go on.

Looked around scrappies for some freelander lights to put in my bumper - no luck. Found them new cheap(ish) on britcar though so I'll just order some. I like the hi-lo brake/tail light conversion.

Found some nice carpet tread plates that had a steel finish with "Land Rover" etched in them though so nabbed them and replaced mine.

After fitting new glow plugs to the 2.25 and still no cold start.Bought and fitted a new resistor today and the cold start is WORKING

Fitted a new hazard switch after the indicators decided to stop work And recently changed the ignition switch too

Fitted the new fuel pump to my 110

Bugger still isn't right. Looks like the injector washers are next on the list.

ratty said:

Fitted the new fuel pump to my 110

Bugger still isn't right. Looks like the injector washers are next on the list.

Click to expand...

day-cha-vu

Taday on my Disco 300TDi I sorted the exhaust mount, done the bump stops and half made some extended bump stops.

Other day I camel cut, trimmed end caps, removed the valance and had some 235/85/16's fitted

Used it to overtake a grab lorry....
End of story

Stripped the rear interior out, taken the rear bumper off and straightend the mounting on the chassis. Removed rear crossmember bolts and mounts ready to put new crossmember on tomorrow. Lots of welding to do.

Looked at it and cried :_(

Why, what ya done to it goldilocks

Argument with a transit

Bugger! you ok?