I have indeed, no sign of leak, and for a metal pipe it would be pretty obvious, only one bit of rubber in the hydraulic system and it didn't look perished at all.
What have you done to your Landie today.
- Thread starter madfrank
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
I have indeed, no sign of leak, and for a metal pipe it would be pretty obvious, only one bit of rubber in the hydraulic system and it didn't look perished at all.
Thanks very much mate, i shall blame you when they break again
I cant see how the master cylinder broke after 6 months of use. What a pain
- Posts
- 67,751
- Location
- halfway between here and there.
Thanks very much mate, i shall blame you when they break again
I cant see how the master cylinder broke after 6 months of use. What a pain
the master cylinder can be badly made,this might result in the seal's leaking etc.was it a blue box one.
discomark10
Well-Known Member
- Posts
- 3,977
- Location
- Milton Keynes
What model is yours. I got a lockhead slave that I brought but was the wrong thread for mine.
i got a blue box one first, it leaked the moment i fitted it, worse then the one i was replacing, then got a trw one or what ever they are all. Slightly more expensive.
tis a 1989 90, LT77 gearbox, got a 200tdi in it, so i think they were the right parts
truckerkev65
New Member
- Posts
- 124
- Location
- sheffield
just gave the old girl a service
SteNova
Well-Known Member
- Posts
- 2,200
- Location
- N. Wales, LL22
the_wolf
Well-Known Member
- Posts
- 16,791
- Location
- Stonehouse, Scotland
Disco seats? How did you do it? I had a look at the side facing ones but considered it too much of a carry on so i opted for the forward facing disco seats
MR BFG
Active Member
- Posts
- 287
- Location
- Kingsbridge, Devon
Just changed the lift pump in my lunch hour, hopefully this fixes the air in the fuel system and makes her run a little sweeter.
dominicbeesley
Well-Known Member
- Posts
- 1,701
- Location
- Hebden Bridge, West Yorkshire
Yay! Got to use 4wd for all of a quarter of a mile in a hail storm...then got beeped at for stopping to disengage
discomark10
Well-Known Member
- Posts
- 3,977
- Location
- Milton Keynes
tis a 1989 90, LT77 gearbox, got a 200tdi in it, so i think they were the right parts
What i was saying is its going spare if its of any use!
haighy2
New Member
- Posts
- 20
re-trimmed the gear gaitors
discomark10
Well-Known Member
- Posts
- 3,977
- Location
- Milton Keynes
Yes lol.. I have an exta lockhead slave cylinder which is of no use to me. Its new. Would you like to take possession of it?
Last edited:
SteNova
Well-Known Member
- Posts
- 2,200
- Location
- N. Wales, LL22
I got brackets made
Kev@kenninghall
Well-Known Member
- Posts
- 902
- Location
- Norfolk
Handbrake fully refurbished and ready for fitting to the new transfer box. Much easier job when it's off the car and on the kitchen table
Handbrake fully refurbished and ready for fitting to the new transfer box. Much easier job when it's off the car and on the kitchen table
Until SWMBO finds out
Kev@kenninghall
Well-Known Member
- Posts
- 902
- Location
- Norfolk
Chrisw8
Well-Known Member
- Posts
- 1,974
- Location
- Top of the Hill
Kitchens for Gearboxes,
Dining Rooms for Engines.
*simples*
Dining Rooms for Engines.
*simples*
