well its out and now in!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D:D

just a very rough map...

sorry about quality..TURN VOLUME UP!

 
Last edited:
hers some more vid..sorry about quality..if it dont buffer first time try again..

DIRTY tick over..Suoercharger whine..



another



do have a couple of issues..re cooling and steering pump..see other posts please..
 
home made stainless..one center box, small and straight though, splitting into twin outlets exiting either side of car by chassis rails
2 1/2 all the way from y piece..proper stainless headers
 
well i hopes cooling sorted..

now run heater return and pipe from head to lower rad hose/water pump inlet

 
update time!!

first....gems autoboxs..if they av a fault and it goes into fecked mode, ie 3rd gear only..DOES it need test book or similar to remove fault and make operate ok, or will just sorting the fault out do?

ok then..



 
Ahhhhhhhhhhh that sounds amazing.

It moves as well... EEEEEEKKKK. I think I need a few minutes... More sounds please.
 
its running megasquirt due to gems modded ecu blowing up 2 times..the gizmo he fitted expired, he admitted it does not use any voltage regulation..this he is changing..
ecu modding man is modifing and sending back for me to try..apparently i am the first to try without becm...however he did refund me cash.
 
IVE GOT GEARS!!!!! yeah....p38 bosch autobox ecu working with megasquirt....happy bunny

proof to follow...
 
bugger no gears now ..

seems to be in first...but not change up....
 
well i was wrong..do have gears!!

going to get megashift i decided to control zf box...compushift farrrrrrrrr to expensive and besides DOES NOT request engine torque reduction on shifts!!£1000 and harsh gear changes!!so megashift it is!!and at almost 1/5th price!!
 
getting there!!

now i needs to sort out the paint...again!!cos i dont like it..

but first..i need to RE sort out the bonnet, cos i dont like the scoop/bulge..

thing is its awee bit of a git to change due to previous engine..etc..see below.







as you can see, there is alot under the scoop..the best i can come up with is remove scoop..cut out centre of bonnet..weld/pop (welding surly will distort!!)
in plate..then slice oringinal scoop to make thinner and refix to plate..thus making it much narrower...issue is with plate popped to bonnet...will it look pooh??

would love just to stick s/c outa bonnet with bug catcher on top..but thats just too bait!!
 
Back
Top