Washer bottle

How do I remove this. My fill pipe has come off and it's a nightmare trying to get it bk on

The fill pipe is connected through a rubber gasket just a push fit bit awkward but ok

Get underneath to guide it In then stand up to push it in the rest of the way .

no chance people i have soild boost hoses in way

remove the boost hoses or take the headlight/battery box out of the way

L66

easiest way I found is to take off the front bumper, undo the wiring plugs for the foglights, pull off the breather hoses as well and then just undo the 2 star bolts that hold it on. There are a coupleof plastic block that retain teh side parts & these have a metal clip that springs off with a scredriver

A littletap with the hand to break the seal and it just slides off it's runners. You can then get at teh bottle no prob - i did this when I had to replace my headlight washer pump as I couldn't get the foglights out the bumper (rounded & rusted screws, now drilled out & replaced) and I did it all, including refitting the bumper, in less than an hour

RAVE covers the process well but misses out the slap with the hand to break the seal

A couple of times the small pipe from the screen washer pump has fallen off - the way I got to the bottom of the washer bottle was wheel off, plastic inner wing panel unbolted and flexed out of the way, good access to motors and pipes.

Saint is spot on.

Cheers guys grinder will be put bk in garage for the next time I lose my rag with it lol