Van conversion

diko93 · Jan 22, 2014

Im converting a truck cab 90 to a van I have the sides roof and back door is there some special mounts to bolt the sides on or is it just normal holts and washers cheers andy

Jonnyb1990 · Jan 22, 2014

My csw is riveted as far as I can see, and a few welds(unsure which type)

Hope that helps

Southernlandy · Jan 22, 2014

My car was originally a pick up but was converted, hopefully this picture should help you. Mine hasn't got a back door but has a tailgate with a series catflap on the top

mlucas110 · Jan 22, 2014

Just the usual bolts and holdings mine had one on corners and ends, few extra by doors and one on the inside of the tub

Davv · Jan 22, 2014

theres a foam seal that sits between the rear sides and the tub, also rubber one between the sides and the roof if you havent got them

diko93 · Jan 22, 2014

I need the ones between the roof and sides where can I get them? And where can I get the fixings that go in the tubes in the corners?

mark-d · Jan 23, 2014

diko93 said:
Im converting a truck cab 90 to a van I have the sides roof and back door is there some special mounts to bolt the sides on or is it just normal holts and washers cheers andy

you can use the 2 special studs from your truck cab and you will need two more of them for the back corners or you can improvise with washers, the rest are normal nuts and bolts

diko93 · Jan 23, 2014

Cool cheers where can I get these special studs?

mark-d · Jan 23, 2014

not sure but this shows what you need Roof Assembly, Mounting Hardware for Defender - Rovers North - Classic Land Rover Parts

no.17 and attached nuts/washers

Van conversion

diko93

Active Member

Jonnyb1990

Well-Known Member

Southernlandy

Active Member

mlucas110

New Member

Davv

New Member

diko93

Active Member

mark-d

Well-Known Member

diko93

Active Member

mark-d

Well-Known Member

Similar threads