V8 Manifold Series 2A

I am after some advice on the best solution regrading how to adapt the steering box using a Rover v8 in a series 2 as the manifold does not have any clearance.

The manifold is off a discovery 3.9, not sure if I need to use a different manifold set up.

Any help would be greatly appreciated.

years ago I fitted a manifold from a Rover P5B coupe but you may struggle to find a good one now

What does the steering bar fit? Is it over the chassis rail? What, exactly, fouls?

Thank you for the replies, the steering bar sits over the chassis and the track rod end fouls the manifold. I have attached another photo taken from the top to show the manifold and the steering arm. It looks like I need a different set up.

Could you use a shorter tre end and nut? It's a shame you couldn't use a straight arm, it would give you clearance and space for a heat shield

I may sound mad... but are the manifolds handed? Could you swap over & this moves the flange forward?
I can’t remember how I done it it’s been 30+ years ago

If it's any help, the Range Rover classic V8 uses different manifolds L & R
I assume the Disco set-up is identical as the chassis is effectively the same as the RRC.