Tyres

Just had a look at the tyre fitting guide but not up on all the lingo...

Which bit is the rear fender?

same for front endcap and bump stop?

Are these difficult or time consuming things to do?

If these are on offset hubs is this going to reduce the number of modifications needed?

A fender is Yankee for quarter panel.
An end cap is the plastic part on either end of the bumper
A bump stop is the rubber block about 2" x 4" on the uinderside of the chassis above the axle that stops the axle contacting the chassis or the tyre touching the wheelarch.
They're all simple and easy jobs and well worth doing.

Thanks!