transferbox to gearbox
- Thread starter pobby
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Teflon
New Member
- Posts
- 683
Seem to recall its about £350ish, give or take the VAT.
Teflon
New Member
- Posts
- 683
Well, its more expensive than an Over-Drive.....
alternatives are to use the LT230 box, to which you need to add teh cost of a centre diff conversion (also from Ashcrofts, and I seem to recall around £150ish) to make that part time 4wd selectable, and then £200 ish to add 3.5:1 diffs to bring the gearing back up to what the Series X-fer had, and get the benefit of the 5th gear back....
Or run the LT230 permenant 4WD and pay as much for a CV joint conversion on the front axle or a Stage 1 front axle so you dont get notch horrible steering and lots of UJ failures......
'Copatability; is all 'relative'........ or 'expensive' depending on your point of view!
dr pepper
New Member
- Posts
- 1,438
- Location
- lancashire
If ou know someone with a surface grinder I beleive you can have the centre diff modded from the disco to selectable, or if you want to bdge you can angle grind it, but I wouldnt want to do that on a permanent job.
T'other thing you need to be aware of is that the '77 and '380 box's are a diffo length to the series so you'd need to have the propshafts modded too.
T'other thing you need to be aware of is that the '77 and '380 box's are a diffo length to the series so you'd need to have the propshafts modded too.
