P38A There is always something

Datatek · Feb 9, 2019

Loaded up the shopping, got into the car, key will not turn in the ignition. No amount wiggling helped. It has happened before but a quick wiggle freed it, not this time. Luckily wife had the spare key, with a bit of a wiggle that turned. Looks like the lock barrel pins are shot.
Dealer seems to think a new steering column is needed, they say the barrel cannot be removed which is not true as I have done it.

Looks like I'll be knocking the pins out so any flat bit of metal will turn the ignition on.

Never a dull moment.

RangeRoller dt · Feb 9, 2019

When I lost the key to my defender the barrel was so worn that I used a teaspoon to start it for a week til the key turned up

Datatek · Feb 9, 2019

RangeRoller dt said:
When I lost the key to my defender the barrel was so worn that I used a teaspoon to start it for a week til the key turned up

Mines the opposite problem

RangeRoller dt · Feb 9, 2019

You have done it before though, or you know it is a pain?
Is the green ring around it supposed to light up?

Datatek · Feb 9, 2019

RangeRoller dt said:
You have done it before though, or you know it is a pain?
Is the green ring around it supposed to light up?

Yes the green ring does light up. I have done it before, I swapped the knackered ignition barrel on my project car with the good one from my scrapper and when I get time I will swap the barrel in the door handle.

oakey · Feb 9, 2019

Ooooops my green ring round the keyhole has never lit up

ukadamwest · Feb 9, 2019

oakey said:
Ooooops my green ring round the keyhole has never lit up

filth !

oakey · Feb 9, 2019

I did say it was green and was being serious

RovyCouple · Aug 18, 2020

My key barrel has difficulty popping out on key removal, it has to be pressed fully in for it to pop out, I'm told that if by oversight one doesn't pop it out it flattens the battery,
I'd like to take it apart to give it a bloody good clean without the barrel falling apart, anyone done it, videos please?

Tenebreaux · Aug 18, 2020

Datatek said:
Yes the green ring does light up. I have done it before, I swapped the knackered ignition barrel on my project car with the good one from my scrapper and when I get time I will swap the barrel in the door handle.

How do you change the bulb?

RangeRoller dt · Aug 18, 2020

I did do it after.
Well I swapped it for the ashtray one while it was apart...shhh!

Take the shroud off (bloomin potch!) and it’s right there.

kermit_rr · Aug 18, 2020

Tenebreaux said:
How do you change the bulb?

There's a thread dedicated to jokes

kermit_rr · Aug 18, 2020

RovyCouple said:
My key barrel has difficulty popping out on key removal, it has to be pressed fully in for it to pop out, I'm told that if by oversight one doesn't pop it out it flattens the battery,
I'd like to take it apart to give it a bloody good clean without the barrel falling apart, anyone done it, videos please?

Wonder if this is why my battery was randomly flat this evening?

RangeRoller dt · Aug 18, 2020

He’s more used to candles

RangeRoller dt · Aug 18, 2020

kermit_rr said:
Wonder if this is why my battery was randomly flat this evening?

Usually beeps saying on dash key in ignition when it sticks.

Tenebreaux · Aug 18, 2020

My ashtray one doesn't work eithe. In fact, I'm not sure if any of my interior bulbs work apart from one in the roof light.

kermit_rr · Aug 18, 2020

RangeRoller dt said:
Usually beeps saying on dash key in ignition when it sticks.

Good point. Didn't get that unless i wasn't paying attention. It was just flatter than a flat thing

RangeRoller dt · Aug 18, 2020

Tenebreaux said:
My ashtray one doesn't work eithe. In fact, I'm not sure if any of my interior bulbs work apart from one in the roof light.

I turn my interior lights off out of sheer paranoia left over from my pre 1000cca days.
Hold middle button for few seconds turn on/off
I get annoyed with myself if I forget to reset it after a battery disconnect

brianp38dse · Aug 18, 2020

RovyCouple said:
My key barrel has difficulty popping out on key removal, it has to be pressed fully in for it to pop out, I'm told that if by oversight one doesn't pop it out it flattens the battery,
I'd like to take it apart to give it a bloody good clean without the barrel falling apart, anyone done it, videos please?

Give the lock a couple of good squirts of electrical contact cleaner inside (do not use wd40) and a bit of key wiggling then let it dry or blast out with air line and use some graphite lock powder puffed in.

Grrrrrr · Aug 18, 2020

RovyCouple said:
My key barrel has difficulty popping out on key removal, it has to be pressed fully in for it to pop out, I'm told that if by oversight one doesn't pop it out it flattens the battery,
I'd like to take it apart to give it a bloody good clean without the barrel falling apart, anyone done it, videos please?

Wot Brian said. You can get a pack of 4 mini spray cans of graphite powder on Amazon for not a lot. Orange caps on mine.

P38A There is always something

Well-Known Member

Well-Sprung Member

Well-Known Member

Well-Sprung Member

Well-Known Member

Well-Known Member

Well-Known Member

Well-Known Member

Active Member

Well-Known Member

Well-Sprung Member

Very

Very

Well-Sprung Member

Well-Sprung Member

Well-Known Member

Very

Well-Sprung Member

Well-Known Member

Technician, Bodgit & Scarper Ltd

Similar threads