Disco 2 Td5 power loss for a few seconds on start

tulipandthistle · Mar 31, 2016

Hi All,
As the title, when I start the Td5 it runs on the first go. However sometimes it just doesn't have the power for a short while but it picks up after a bit. It is just when I drive off it doesn't have the power but within a few seconds it regains power and drives perfectly after that.

It doesn't always do it. Any ideas?

johnlad · Mar 31, 2016

sounds like classic maf fault symptom, when its failed it takes the ecu a few seconds to realise and come up with default settings

tulipandthistle · Mar 31, 2016

johnlad said:
sounds like classic maf fault symptom, when its failed it takes the ecu a few seconds to realise and come up with default settings

Would that show up on my Nanocom?

johnlad · Mar 31, 2016

It should do either as a low reading at tick over as it should be between 50-60 or as no signal at all

tulipandthistle · Mar 31, 2016

cheers, I will check that in the weekend.

sierrafery · Apr 1, 2016

What about oil in the ECU red plug though? ... anyway if you have nanocom read fault codes first cos it might be one relevant

tulipandthistle · Apr 1, 2016

I will check that as well while I am at it! Cheers Sierrafery.

tulipandthistle · Apr 3, 2016

OK no oil in the red plug. I had a fault code though: injector 1 open circuit detected

I saw the airflow gr/hr on 4.3, am i looking at the right one? If so it is no where near 50-60.

Are these issues related?

sierrafery · Apr 3, 2016

The injector open circuit can be caused by injector loom even if there's no oil in the red plug YET, that MAF reading means the sensor or it's wiring is fubar'd, unplug it and drive it so, if it's noticeable improvement buy a new VDO one if no change check the wiring cos it used to get chaffed in front of the engine where it goes down, and check fuse F2 in engine bay too just to be ruled out

tulipandthistle · Apr 3, 2016

sierrafery said:
The injector open circuit can be caused by injector loom even if there's no oil in the red plug YET, that MAF reading means the sensor or it's wiring is fubar'd, unplug it and drive it so, if it's noticeable improvement buy a new VDO one if no change check the wiring cos it used to get chaffed in front of the engine where it goes down, and check fuse F2 in engine bay too just to be ruled out

Cheers, I will do that. Thanks for your time again Sierraferry.

tulipandthistle · Apr 4, 2016

OK, disconnected the MAF, not sure if it made a difference. It seemed to be better in lower refs. While disconnected it still did the less power for a few seconds thing.
F2 is fine. It looks like the wiring was done before so it might be worth investigating.

johnlad · Apr 4, 2016

You need a new maf sensor

tulipandthistle · Apr 5, 2016

cheers VDO sensor it is then. I bite the bullet.

iansoady · Apr 5, 2016

I always get one injector open circuit when the engine isn't running.......

johnlad · Apr 5, 2016

Injector open circuit is usually a fault on the injection loom, probably contaminated with oil so worth changing it

tulipandthistle · Apr 5, 2016

I did mine only half a year ago

sierrafery · Apr 5, 2016

but was it genuine loom?...cos aftermarkets used to last less than a year from time to time

tulipandthistle · Apr 5, 2016

sierrafery said:
but was it genuine loom?...cos aftermarkets used to last less than a year from time to time

no not genuine, this one lasted 9000 miles

sierrafery · Apr 5, 2016

that's about it for an aftermarket IMO

tulipandthistle · Apr 5, 2016

sierrafery said:
that's about it for an aftermarket IMO

Fair enough it was very cheap. ;-) the next one won't be though

Disco 2 Td5 power loss for a few seconds on start

Active Member

Well-Known Member

Active Member

Well-Known Member

Active Member

Well-Known Member

Active Member

Active Member

Well-Known Member

Active Member

Active Member

Well-Known Member

Active Member

Active Member

Well-Known Member

Active Member

Well-Known Member

Active Member

Well-Known Member

Active Member

Similar threads