TD5 Camshaft Head Sealing

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
C

chubba

Member
Posts
13
Location
Australia
Going to use Loctite 518 to put the two halves of the head back together.

Just wondering if the sealant goes on all flat surfaces (including head bolt hole surfaces) or just around the outside?
 
RAVE shows where to put the sealant. Ideally use a roller.
Dont use too much, you dont want to block the oil ways that feed the cam.
Looking at the spec I guess Loctite 518 is a suitable alternative to the Hylomar RAVE says to use, probably cheaper, the Hylomar is about £45!
Mark
 
You must log in or register to reply here.

Similar threads

Rich W
Disco 2 TD5 camshaft rotation torque
Replies
5
Views
434
Rich W
Rich W
Maat
Disco 2 Can a TD5 engine be removed out of the engine bay without the cylinder head on?
Replies
8
Views
514
Maat
Maat
B
TD5 Temp gauge drops to 1/4
Replies
3
Views
410
Bugz
B
D
D2 new front prop shaft and grease question
Replies
4
Views
827
Disco Magic
D
stumpyj
Fuel Line worn through
Replies
2
Views
208
stumpyj
stumpyj
Back
Top