Td5 boosts then dies I each gear.

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
might have been but it didnt look so... he bought it this way but not from new, in this case my apologies though the overboost symptom is caused by not working wastegate IMO
 
I have spoken to the landrover garage and they believe it's the fuel pump not working properly. It's booked in on Thursday for a proper diagnosis.
Do you agree this could be the cause of lack of power mid/high revs in each gear even when gently pushing the accelerator?
 
Rufiopb said:
I have spoken to the landrover garage and they believe it's the fuel pump not working properly. It's booked in on Thursday for a proper diagnosis.
Do you agree this could be the cause of lack of power mid/high revs in each gear even when gently pushing the accelerator?
Click to expand...
all depends
are you making power down low ie are you boosting under load .
without knowing boost reading or fuel pressure readings as you mentioned in the first post you can feel the turbo kick in an pulls nice

before you take your vehicle in this gives you time to mark things so when you get the bill you know what has been tampered with just saying
 
Last edited:
That's what I'm worried about. How much would you expert for a new fuel pump + fitment?

Yeah it definatly boosts to start with them dies.

I'll also mention the waste gate too.
 
Right so hot the lr back. Basically the owner previous to me had turned the boost up and not enough air was getting through the air filter. So they took the filter out and get Preston works fine. Thing is I need a good air filter. Any recommendations? If this doesn't work then I'll turn boost down via the waste gate. Hopefully that's straight forward enough. Also got a new MAF AND A BOOST PIPE WAS collapsing. But the culprit was the panel filter.
 
Put the KnN air filter today. And now it works perfectly. No lag and more boost. The is for all your help. Just shows that the KnN filters do actually work!
 
neilly said:
Still does not answer the question why yours needs the k&n filter when thousands of others do not???

Cheers
Click to expand...

15 threads were showing. Turbo boost had been turned up. A collapsing hose, a faulty MAF all contributed. Not enough air was getting in. I will turn the boost down a tad when I've got time. But at the moment I am just enjoying it.

I'm sure I mentioned it in a previous post.
 
Rufiopb said:
15 threads were showing. Turbo boost had been turned up. A collapsing hose, a faulty MAF all contributed. Not enough air was getting in. I will turn the boost down a tad when I've got time. But at the moment I am just enjoying it.

I'm sure I mentioned it in a previous post.
Click to expand...
turning up the boost should still have not any affect using the original filter best to fix the collapsing hose as it may get weaker over time

also waste gate rod length should never adjust this unless there is a boost gauge installed
 
Last edited:
True, youve still may not have found the underlying cause.

My 90 was running 18psi before a map or any other mods, ran perfectly for the whole time I had it (engine wise)

Though youve replaced a collapsed hose and a new MAF, id go back to the standard filter and see if it happens again
 
You must log in or register to reply here.

Similar threads

T
Gear selection problem
Replies
3
Views
271
miktdish
miktdish
bahteles
Disco 2 Discovery td5 auto cutting out after 2.500 rpm [Solved]
Replies
15
Views
2K
Steven Sheppard
S
Sue1962
08 Plate Freelander 2 TD4 Sport - Gear Change issues & Lack of Power
Replies
1
Views
650
freelance
freelance
C
Disco 2 Td5 no power, changed loads and at a loss.
2 3 4
Replies
74
Views
4K
EeEk
EeEk
bahteles
Disco 2 Td5 No power after 2.5k - 3k RPM
2
Replies
26
Views
1K
sierrafery
sierrafery
Back
Top