Boaby52
Member
- Posts
- 25
- Location
- Airdrie North Lanarkshire
Hi I have a 2005 td4 freelander 1 I am trying to change fuel filter at drivers side rear wheel arch any tips on how to remove two 10ml bolts holding tray on they are very corroded
TD4 fuel filter tray bolts
- Thread starter Boaby52
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
saxavordian
Well-Known Member
- Posts
- 9,823
WD40 and allow for the oil to penetrate. Next very very careful when unbolting as they can snap.
Madmustang
Well-Known Member
- Posts
- 1,671
- Location
- Castleford
And old post I know but I just bought one of these http://www.go2socket.com/
For $25 and i wish I had had one years ago....
For $25 and i wish I had had one years ago....
Boaby52
Member
- Posts
- 25
- Location
- Airdrie North Lanarkshire
Hi does this socket reach both 10mm bolts
Madmustang
Well-Known Member
- Posts
- 1,671
- Location
- Castleford
Not sure fella I have never had to take one off
these are supposed to be good .. according to previous LZ posts
( i have some .. but yet to need .. or try them )
set with a 10mm socket
https://www.machinemart.co.uk/p/5-piece-bolt-grip-set-expansion-set/
other sets :
https://www.machinemart.co.uk/p/5-piece-bolt-grip-set/
https://www.machinemart.co.uk/p/irwin-lugnut-bolt-grip-set/
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
( i have some .. but yet to need .. or try them )
set with a 10mm socket
https://www.machinemart.co.uk/p/5-piece-bolt-grip-set-expansion-set/
other sets :
https://www.machinemart.co.uk/p/5-piece-bolt-grip-set/
https://www.machinemart.co.uk/p/irwin-lugnut-bolt-grip-set/
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
