Taking a line from engine bay into cabin

SpudH · Jan 24, 2010

Hi Guys,

I want to fit an air guage in the cabin, at the moment it's in the engine bay. Anyone know a neat way of getting through the bulkhead.

I'm loathe to drill a new hole, even though I have a stock of grommets but with all the sound insulation in the engine bay I can't make out where the wiring looms go through

Any suggestions?

PS search is dominated by series bulkhead threads so don't try that

gavbriggs · Jan 24, 2010

is there no way through at all, i put a wire into cab but i cheated and ran it round the door frame and under the dash. i want to get the wire put in properly but same as you couldnt find a hole!

rewmer · Jan 24, 2010

There is a grommet with a bit of room on the right hand side of the engine bay on the bulkead. It comes out just above the throttle pedal. Should do the job.

overlandrover · Jan 24, 2010

If you have cruise control, try and follow the vacuum pipe from that as it goes through the bulk head above the pedals, i can just see mine from the engine bay.

SpudH · Jan 24, 2010

overlandrover said:
If you have cruise control, try and follow the vacuum pipe from that as it goes through the bulk head above the pedals, i can just see mine from the engine bay.

OOh, hadn't thought of that, nice one!!

I tried Rewmers suggestion but its a real bitch to try and get anything through. I even chamfered the air hose but I couldn't get it through. I can't even figure what thickness the bulkhead is?

Taking a line from engine bay into cabin

SpudH

Well-Known Member

gavbriggs

Well-Known Member

rewmer

Well-Known Member

overlandrover

New Member

SpudH

Well-Known Member

Similar threads