Freelander 1 Swinging exhaust

Drove to work this morning and there was a rumbling sound on occasions.
I checked underneath and found that the rear exhaust box has lost its rubbers and is swinging side to side. I don't have any way to do a temporary holding job so do I risk driving 20 miles back home after work or does this warrant a call out for the breakdown service I am in?
I wish I could find some wire to do a temporary fix but unlikely where I work.

There must be something you can use as a temp fix, a bit of stout string, cable tie, a few rubber bands etc.

Col

I have just found some electrical cable
I will try a temporary fix with that.

dog-man said:

I have just found some electrical cable
I will try a temporary fix with that.

Click to expand...

You should be fine with that. If possible, strip the plastic insulation off it first! Also maybe a wire coat hanger or bit of fencing wire?

I am limited at what I can source here at work.
I was lucky to find some short lengths of earth cable. I can pop into halfrauds on way home if it lasts that long.

You should add a Poll to this thread on how long your "temporary fix" will be installed before you get new rubbers.

My vote is on 8 months.

Already ordered and I will pick them up on way home. I will fit them tomorrow.
Just done the temporary fix. The rubbers were in place but terribly worn and useless.
Had to use a long piece of ethernet cable to do the fix as nothing else I could find was long enough. I did find a metal coat hanger and tried to use that but it was tougher than any hanger I have ever encountered so it would not cooperate when trying to use that, so had to abandon that idea. Only tool I had was a pocket multitool.
Anyway, it should get me home. I will try and find another cable to have in reserve should it fail part way home.