Sunroof

Might be a bit of a daft question this but when closing the sunroof from being tilted open, it doesn't seem to close all the way down.

If you hold button in till it stops, sunroof looks slightly open. If you stand on side steps you can see it slightly raised.

Am I not closing it correctly or missing something?

You don't need to hold the switch down whilst the sunroof's in operation, it's 'one touch'. Just press it once depending in what u want it to do (either push inwards (or up) once for the back to pop up, or push the switch backwards once towards the rear of the car for it to fully open IIRC)
IIRC when closing, the back comes up slightly just as it's about to close to seal properly against the roof.

Cheers, think mines a bit goofy then. If I only press once and release it only lowers by a couple of centimetres.

I will give it another go

If it still doesn't close properly you made need to reset the closed position sensor

Hold the close button for around 20 seconds, you will hear the sun roof attempt to close shut. Then open and close fully and the glass should be back to its normal position

Good luck

Cheers will give that a go

if hippos suggestion dont work the switch maybe knackered,you can adjust the glass in the hole by removing the bellows on either side of the glass and undo the torx bolts (t20 i think) adjust the glass untill its about 2mm higher or lower than the roof and re-tighten the torx bolts.