Steering wobble

rob_90 · Jan 20, 2014

Ive found the prob the back left trailing arm i can rattle when on the floor the bushes are toatally shot the three 17mm nut are undone but the one on the chassis and axel are well tight any tips??? Ive soaked it in wd40 for tonight

Marmaduke · Jan 20, 2014

I cut mine off with an angle grinder and replaced them all, for the the axle/trailing arm bush I used plasma disks from machine mart that are 1mm thick as the bush had rusted to the bolt running through it

IamRobbie · Jan 20, 2014

rob_90 said:
Ive found the prob the back left trailing arm i can rattle when on the floor the bushes are toatally shot the three 17mm nut are undone but the one on the chassis and axel are well tight any tips??? Ive soaked it in wd40 for tonight

i cut mine with a angle grinder but the s**t that comes off it and the smell it terrible so enjoy.. I only did 1 it was that bad, got the other to change this year

wickford90 · Jan 20, 2014

rob_90 said:
Ive found the prob the back left trailing arm i can rattle when on the floor the bushes are toatally shot the three 17mm nut are undone but the one on the chassis and axel are well tight any tips??? Ive soaked it in wd40 for tonight

Get a breaker bar as long as poss to crack it, or can you get a rattle gun on it.

IamRobbie · Jan 20, 2014

I think with the bolt that goes through the axle i got a 400mm breaker bar and actually kicked it under the 90 over and over again, it was a ball ache, same with the nut on the other end

wickford90 · Jan 20, 2014

did you put a spanner on the other end to stop it turning.

Steering wobble

rob_90

New Member

Marmaduke

Well-Known Member

IamRobbie

Well-Known Member

wickford90

Well-Known Member

IamRobbie

Well-Known Member

wickford90

Well-Known Member

Similar threads