steering wheel removal help/how to....
- Thread starter aquifer
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
I would imagine the centre badge would have to be levered out to get to the nut
Last edited:
Hicap phill
Well-Known Member
- Posts
- 15,421
- Location
- Wiltshire
Remove the Landrover plastic insert with a small/fine screw driver.
Behind this is the nut.
You can make an extractor if needed.
Behind this is the nut.
You can make an extractor if needed.
mick the builder
Well-Known Member
- Posts
- 5,901
- Location
- Sligo,Wild West of Ireland.
Leave nut on a couple of turns before trying to yank off the steering wheel, it might save you a few teeth. 
- Posts
- 83,230
- Location
- Embasinga stocæ
£12 on the bay of fleas
frog hopper
Well-Known Member
- Posts
- 4,709
- Location
- france
Pretty easy to make if you have a bit of steel hanging about, a pillar drill, some threading taps and various bolts and and and
Well £12 seems pretty darn good to me.
Well £12 seems pretty darn good to me.
micknkatenki
Active Member
- Posts
- 438
- Location
- Lincolnshire
as above, or tap the underside with a rubber mallet gently
- Posts
- 83,230
- Location
- Embasinga stocæ
well?
ogb
Active Member
- Posts
- 289
- Location
- Moray, NE Scotland
Tried all the above with no success...any more offers?
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
Hicap phill
Well-Known Member
- Posts
- 15,421
- Location
- Wiltshire
Unofficial way.
Wedge knees behind steering wheel & apply pressure.
Hit with a Copper hammer on to the colum with the nut still loose.
Wedge knees behind steering wheel & apply pressure.
Hit with a Copper hammer on to the colum with the nut still loose.
ogb
Active Member
- Posts
- 289
- Location
- Moray, NE Scotland
Tried that too.
I've given up. The OEM wheel does the job well enough and I can live with the off-centre position even though it "grinds my gears" that it isn't right. My concern now is for future maintenance - I like to be sure that everything that should come apart actually will, and this doesn't.
Hicap phill
Well-Known Member
- Posts
- 15,421
- Location
- Wiltshire
If it's off centre just adjust the steering tube from box to axle.
Or knock the UJs between colum & box
Or knock the UJs between colum & box
bluedog333
Well-Known Member
- Posts
- 5,338
- Location
- Henley on Thames, Oxfordshire
bluedog333
Well-Known Member
- Posts
- 5,338
- Location
- Henley on Thames, Oxfordshire
ogb
Active Member
- Posts
- 289
- Location
- Moray, NE Scotland
Yep, valid comment
