squeal
- Thread starter sean1970
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
mysteryman
New Member
- Posts
- 1,626
- Location
- Coleford, Forest of Dean
change/tighten the belt???
mysteryman
New Member
- Posts
- 1,626
- Location
- Coleford, Forest of Dean
Not too bad - you have to take the engine out (but not the gearbox) to have full access to the belt. but that dont take too long and is worth the effort in the end
- Posts
- 83,230
- Location
- Embasinga stocæ
the usual?
gallon of petrol and a match. :behindsofa:
gallon of petrol and a match. :behindsofa:
steely dan
Active Member
- Posts
- 195
- Location
- County Kerry Ireland
Try some builders chalk or talcom powder.
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
i was think more on the lines of taking it for a drive at breen sands
the sea air should help (just before the rising tide)
Take no notice of those horrible men and their insults, the best thing to do is wait for a dry day and then warm the engine up for about fifteen minutes.
That should temporarily stop the squeal for long enough for you to drive to your local dealer and trade the ****er in for a Defender.
That should temporarily stop the squeal for long enough for you to drive to your local dealer and trade the ****er in for a Defender.
mysteryman
New Member
- Posts
- 1,626
- Location
- Coleford, Forest of Dean
Nice one......
buckshot
Well-Known Member
- Posts
- 9,841
- Location
- right yer!
Hippo
Lord Hippo
- Posts
- 51,947
It's probablt the auiliary belt. It’s squealing due to the belt slipping. The belt tensioner is automatic. This should apply the right amount of tension on the belt. Take off the plastic side trim between the driver front wheel and the engine. It’s held by 3 bolts at the top, and slots in to the engine guard at the bottom. This will allow you quick access to the auxiliary belt. Check the belt to see if it’s tight enough. Also check it’s not stretched. You’ll see stress marks in it if it is. You can turn the bottom pulley to allow you to see the whole belt, as it move round the cogs. Don’t go near the belt when the engines running!
Have a look at the rave disk link below.
Have a look at the rave disk link below.
