Speedo transducer

t0m1980 · Mar 19, 2019

evening all,

So following this,
http://www.retroanaconda.com/landrover/2009/10/installing-defender-td5-gauges-into-a-200tdi300tdi/

Is there anything else I need to put on the transducer, or does it just sit in the hole and gets screwed down?

The reason I ask is what’s in there already looks to be screwed down with two nuts and this new one has nothing? Obviously it has a different hole which I presume tightens it down.

I apologise for the poor writing in the picture, it was done on my phone with fat sausage fingers

t0m1980 · Mar 19, 2019

Hopefully that will make it a bit

clearer than mud

mick 1986 · Mar 19, 2019

t0m1980 said:
View attachment 172974 View attachment 172973

Hopefully that will make it a bit View attachment 172975 clearer than mud

Mine is like the bottom photo in this post.

It gets pushed in, and secured with a single bolt.

t0m1980 · Mar 19, 2019

Ok thanks, did you use any sealant as well or just the screw?

mick 1986 · Mar 19, 2019

t0m1980 said:
Ok thanks, did you use any sealant as well or just the screw?

Just screwed it in. I can’t remeber if it had a seal or not though.

t0m1980 · Mar 19, 2019

Thanks Mick, much appreciated

Rougharse Racing · Mar 20, 2019

The speedo transducer goes here. Held on with one bolt.

t0m1980 · Mar 20, 2019

Thanks for that..... shame I didn’t know that earlier;

https://www.landyzone.co.uk/land-rover/just-ignore-this-one.343585/

Speedo transducer

t0m1980

Active Member

t0m1980

Active Member

mick 1986

Well-Known Member

t0m1980

Active Member

mick 1986

Well-Known Member

t0m1980

Active Member

Rougharse Racing

Well-Known Member

t0m1980

Active Member

Similar threads