Soft 'A' Bar fitting (STC50413)
- Thread starter tjcorsa
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
kernowdragon
Well-Known Member
- Posts
- 1,918
- Location
- Wickford, Essex
You could try the Paddocks site, they have a download area with quite a number of instruction sets for various accessories.
Bonkers
Active Member
- Posts
- 410
- Location
- Northampton
Just bought a soft 'a' bar part no stc50413 off ebay and it's come with no instructions!! I have four brackets (2 short & 2 long) and a collection of fixings but am not sure where it fits too
can anyone help?
Thanks in advance
Trevor
Try searching this site - the question has been asked before and at least one member found the instructions on the web.
garythegrass
New Member
- Posts
- 82
hi its on the rave disc when you take the bumper of the civ lights and markings to drill ar marked on the back of bumper to short fit in side the bumper grill two lugs and the long ones go under neith wear the engine under tray bolts on hope it helps good luck
Try here..................
http://www.ownerinfo.landrover.com/...le?t=1295200618606/Protection_Bar_A_Frame.pdf
http://www.ownerinfo.landrover.com/...le?t=1295200618606/Protection_Bar_A_Frame.pdf
bg_freelander
Active Member
- Posts
- 121
Ian jones
Well-Known Member
- Posts
- 1,104
- Location
- north east england
That is on a early freelander !
Morten 1
Active Member
- Posts
- 161
- Location
- Bergen,Norway
I might be mistaking, but I think the TD4 has the longer front bumper? Like the V6 front? I would have checked the angels of the A bar before I bought one unseen.
bg_freelander
Active Member
- Posts
- 121
I saw pichtures with several Td4 with this nudge bar fitted and there is a seller in ebah which describes the nudge bar as "not suitable for Td4"
