Servo

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

border

Well-Known Member
Posts
3,517
Location
North East. UK
Need to join the Vac Pump to Servo, in pic, Did not see or know what should originally be used, studied pics of same conversion, some have just rubber hose and some have what look like plastic fuel lines. Rubber hose and jubilee clips looks the easiest.
 

Attachments

  • IMG_20200318_181856_LI.jpg
    IMG_20200318_181856_LI.jpg
    250.7 KB · Views: 84
I used thick wall rubber hose incase normal walled stuff could suck flat.
Think it was 1/2" or 13mm internal bore, long time ago...
 
I think it is special hose, because it is a vacuum not pressure.
I think normal hose may collapse and block, servo hoses are quite hard when you try and crush them.
Have a route around, the hose from any Land Rover should do, If you find a Discovery hose, you may need to shorten the plastic part.
 
The vacuum pressure really isn't that much, to put it into perspective, a hoover hose isn't strong at all and the hose on a blocked hoover won't implode, you would get away with heater hose if you had nothing else.
 
The vacuum pressure really isn't that much, to put it into perspective, a hoover hose isn't strong at all and the hose on a blocked hoover won't implode, you would get away with heater hose if you had nothing else.
Thanks, Will try and get some off a Disco and cut it down, but may try the heater hose if I need to
 
Back
Top