Series rover mudding tips?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
but mooring line is different........if it gives way as it's designed to, all that stored energy disappates without whipping back and decapitating people, should hear the noise a 4" line makes when that lets go........actually nothing to be honest, just a small ripping sound as the filaments break gradually.
 
Grippa said:
Yer could mek a fillum - 'Horizontal Limit'. :D
Click to expand...

Cud yer imagine belaying him? If he fell you'd have 1/1000th of a sec to decide whether to:

hold the rope and strip the flesh off yer palms as it whistled through the belay device :eek:

Jam the belay device and be rocketed skywards as Si hurtled towards ya. :eek: :eek:

Let the fooker go and hope you haven't let it coil round yer feet while you've been taking the slack in :eek: :D :D :D
 
Well I learned a lot about rope in this thread, but less about mud driving than I had hoped. My tires are a step above tractor tires, hard as a rock, I have a spare set of rims though and I might invest in some good ATRs.

P.S I had the rover in low range, but I was only going 4 or 5 mph. I think I needed more momentum.
 
G-man said:
you say a step above tractor tyres? what tyres are they?
Click to expand...

The previous owner saved them out of a salvage yard I believe. I've never seen anything like them. They are very knobby and very hard. They seem to be in good condition though, so I'm not worried about replacing them just yet. There is no manufacturer's recommended psi so I pumped them up enough that they don't bulge out on a concrete surface (going for slightly better mileage if possible) that happened to be about 40 psi
 
Lower the pressure the better the grip. As there is more tyre in contact with the ground.and the tyres flexing will help to clean the mud off the treads. Invest in a decent air compressor and deflate your tyres to around 15-20Psi when driving in the slippery stuff. Then inflate them back to no more than 35Psi Manufacturers max pressure is just that the max you should inflate them too not the pressure to aim for all the time. If the tyres are very knobbly and you have them at full pressure, you'll have 2 or 3 of the treads blocks in contact with the road at any one time. That's not a lot of grip. let some air out. Tyres are supposed to bulge slightly outwards.
 
You must log in or register to reply here.

Similar threads

P38 Monkey
P38 heater o-rings: draining tips?
2 3 4
Replies
60
Views
4K
P38 Monkey
P38 Monkey
K
What money should I be asking?
2
Replies
27
Views
5K
Karls
K
A
L322 Waterpump recommendation? (M62 -03)
Replies
2
Views
496
AndersForsberg
A
ChrisBduck
3.6L Land rover 90
Replies
2
Views
1K
ChrisBduck
ChrisBduck
W
Land Rover series 3 Daihatsu diesel
Replies
8
Views
1K
tottot
tottot
Back
Top