Roll Bar

C

clanur

New Member

Posts

4

• Feb 23, 2009

• #1

Hello,

Can anyone tellme if a roll bar from a 90 will fit on a series 3?

Are the chassis's the same width. It is just a basic hoop with back brace, 4 bolt on plates in total.

Thanks
Pat

:doh:

 

jimbot90

New Member

Posts

4,410

Location

notts/derbys area

• Feb 23, 2009

• #2

i think thi might be,thi about the same width at the front.if not just put bigger plates on.

 

B

Beast o Bodmin

Banned

Posts

17,157

Location

never did like the welsh.....tom jones is also cra

• Feb 23, 2009

• #3

clanur said:

Hello,

Can anyone tellme if a roll bar from a 90 will fit on a series 3?

Are the chassis's the same width. It is just a basic hoop with back brace, 4 bolt on plates in total.

Thanks
Pat

:doh:

Click to expand...

If it dont fit weld it to the rear tub floor.:doh:

 

Mseries3

Well-Known Member

Posts

2,621

Location

Surrey

• Feb 23, 2009

• #4

I think so... They done it on Wheeler Dealers with a bright yellow stage one,,

 

baggyjim

New Member

Posts

2,063

Location

gillingham dorset

• Feb 23, 2009

• #5

Beast o Bodmin said:

If it dont fit weld it to the rear tub floor.:doh:

Click to expand...

what you proposing to do it with as steel dont well to ali very well , perhaps some of your bull**** would stick it in place

 

109party

Well-Known Member

Posts

2,901

Location

Funny place of Norfolk

• Feb 23, 2009

• #6

baggyjim said:

what you proposing to do it with as steel dont well to ali very well , perhaps some of your bull**** would stick it in place

Click to expand...

lol no silly hes gonna use chewing gum or drill holes and put steel bolts through and then in 5 years why its pulled off and left a huge hole from electrolitic corrosion