Replacing bent drag bar

adies_v8 · Jun 2, 2010

1985 90.

the bar that connects the 2 front wheels (drak link i think its called) - where ya tracking's done- behind the axle. not the one that steers the wheels - the one that keeps them apart a set distance.

I had abit of a misshap on monday and its quite bent, wheels out diffrent directions. i have the new bar, any tips for fitting?

will post a pik when i get it off tonght.

cheers

adie

08mckerp · Jun 2, 2010

count the number of threads showing so you know how far to screw the track rod ends onto the new bar. and to get it out dont hit the bottom of the track rod ends else you knacker the thread and wont be able to get the nut back on. hit the casing around it.

ratty · Jun 2, 2010

08mckerp said:
count the number of threads showing so you know how far to screw the track rod ends onto the new bar. and to get it out dont hit the bottom of the track rod ends else you knacker the thread and wont be able to get the nut back on. hit the casing around it.

or screw the nut back on so it just protrudes from the track rod ends and hit the nut instead.

bustersbus · Jun 2, 2010

D'ye mean like this one..

http://www.landyzone.co.uk/lz/f41/track-rod-ends-renewal-99508.html

If ye give the arm where the track rods go through a couple or three chaps with a hammer, it might be enough to just make them pop out

TBH, if ye're changin' the bar ye might as well put new track rod ends in and save yersel' a lot of hassle!

08mckerp · Jun 2, 2010

ratty said:
or screw the nut back on so it just protrudes from the track rod ends and hit the nut instead.

yer, tho if its really stuck and you hit a it a wee bit too hard you can end up trashing the threads if you mess up the castleations or woteva they r called which i hav done so when you wind it on you trash the thread behind it

Replacing bent drag bar

adies_v8

Active Member

08mckerp

New Member

ratty

I'm not special I'm limited edition

bustersbus

Well-Known Member

08mckerp

New Member

Similar threads