remote central locking kit

hi all just got myself a remote central locking kit from good ole ebay
the wiring diagram it **** does not realy explane which wires go where and I'm having trouble
with the feeds to door actuator it only seems to need a + and a - and I need to connect up
from kit an orange, orange//black
yellow, yellow/black
white, white/black
any help please
and where can I download a copy of is it rave manual ?
thanks andy

I assume your kit comes with an ECU and a five wire door lock master actuator replacement.
The diagram in the kit wil show the connections to the ECU and from ECU to the actuator, that will be: 1.lock, 2.unlock, 3.earth/common and two wires away to your four existing slave actuators.
If that's the kit where's the problem?

Disco 1 manual .pdf here...

http://www.landroverresource.com/

I'm using the driver door actuator mine only came with ecu and wiring it all ready got central locking when I use drivers door with key as my original key fob I did not have when got disco

Spong said:

Disco 1 manual .pdf here...

http://www.landroverresource.com/

Click to expand...

Thanks spong for rave

ive just found in the passenger back seat pocket my fob which I guess should be on keys
as the hole in top is now a gap I guess the previous owner put it there now I'm guesing
with this working this should operate my central locking which would fix my issue but it don't
do anything ive put in a new battery got red led now but not doing nothing does
the fob need some sort of re-setting or ?
any help please
andy

If you fob is functional then this who'll you will find in RAVE will program it.

****For single button remotes only****

NOTE: New handsets are supplied in pairs.
If a new handset is required, it will require
initialisation to the ECU using the
following procedure:

1. Starting conditions: ignition off, doors unlocked,
bonnet switch depressed.

2. Carry out instructions 3. to 9. within 8 seconds.

3. Switch ignition ON.

4. Switch ignition OFF.

5. Lock doors.

6. Unlock doors.

7. Release bonnet switch.

8. Switch ignition ON.

9. Switch ignition OFF.

If alarm is correctly accessed, horn will sound and
LED will light. It is now possible to programme two
handsets of correct frequency to vehicle alarm ECU.
This must be carried out within two minutes.

10. Press and hold down button on first handset until
dash LED flashes.

11. Repeat instruction 10. for second handset.

12. The LED will extinguish if both handsets have
been initialised correctly.
.