Recognise these rubbery bits anyone?

Anyone any idea where these panel seals came from?
awhitwell44's's Library | Photobucket
Panels painted and everything going back on - don't want to leave these out. They are bound to be deep down where I can't retrofit them! Not long now.

At the rear of each wing, the bonnet closes on them, discos have them.

discool said:

At the rear of each wing, the bonnet closes on them, discos have them.

Click to expand...

Jeez .. never seen mine look that clean, even when we first got it!!

Ummm - here's the bonnet shutty area (very clean - so far!) and no obvious place for the rubbery bits.
Rangie Bonnet Zone Photo by awhitwell44 | Photobucket
Hope no one can see me wandering around trying to fit them in various places!

Do they fit on the underside of the bonnet?

No, they go left and right at the rear of the engine bay ...




can you see the tubular seal ?

either that or read your Haynes manual, must be piccys in there

discool said:

At the rear of each wing, the bonnet closes on them, discos have them.

Click to expand...

Sorry to disagree Discool but RRC doesn't have those seals because the decker panel will be in the way.

I can't be 100% but the pics the OP referred to look a bit like the two small seals that sit on each side of the radiator but I seem to remember them being a bit longer. Apart from that no idea!

Had a look in my RRC parts book as u do, you may find the seals are #40 in the photo pt number was 399518, but then perhaps not... it's been 15 years since I looked under the bonnet of a RRC.

Thanks everyone. They certainly look like the ones from the Dippypud's picture but they don't fit there on this 1980 RR. I think I can leave them out until I find a similar RR to scrutinise. We did have a P38 that died but I'm sure these seals came from the 1980 Classic.
I'll post a final reply when I find out.

Are they the seals that go between the inner rear wheel arches and the outer wings? They look like the one I removed when welding up my inner arches.