radiator advice

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
C

cheongthong

Active Member
Posts
214
Location
belgium
:Dadvice please what will you do ;;;;;;plastic above the radiator has a tear about 7 to 8 inches , it is beter to replace a new one from ebay ( oem of chinees ) around £ 110 , or to repair it around £85 to £110 radiator is around 15 year old ( original radiator ):confused::confused:
 
put a new one in, I think island4x4 do the nissen one from what I`ve read on here and it must have a baffle in the top on a diesel or it wont work properly, rad top splitting seams to be a common fault bring back the brass topped rads
 
my dse did the same its probably the fact the in and out are both at the top, one half different temp than other two different expansion rates.
 
yes, now i see it is two parts in diesel radiator the hot cooler go down , the fan cool it and the cooler came up again and back to engine
 
If you're going to have the radiator out you might as well do some other bits and bobs while you're at it:

1) Clean out the intercooler. Not a lot comes out but I swear it makes a difference!
2) Replace the alternator belt and the air-con compressor belt.
3) Replace the thermostat. Not worth risking on a Rangie.
4) How old's the water pump? Again, Island 4x4 do the metal impeller one for £33.

That should mean you don't have to take the bar-steward of a viscous off again for a while. Of course, you might be lucky and the previous owner hasn't done it up with a 4' breaker bar!
 
it easy that always change thing , it a cars I drive so i known what going on than always working with this and that , over a certain period of time those thing is going to break down , after changing these you known a least it good for another 80.000 miles
 
crazy , changing the plastic for the copper cost 300 + als they ask for , better buy a new on Ebay ,but will try to fix the crack tomorrow myself , plastic welding of solder with nylon
 
NOT PLASTIC , a nylon pipe of small nylon rob and a solder iron 100 watt above mine I use a 200 watt ,, melt the crack and the rod together and fill it , it done , have start and run the engine till very hot and no leaked
 
You must log in or register to reply here.

Similar threads

dag019
Radiator options
Replies
19
Views
2K
Bobsticle
Bobsticle
M
P38A Leak
Replies
2
Views
1K
nigelbb
N
K
New Member Intro
Replies
7
Views
669
KIWIWOLF
K
Almonds
Help Request: 300TDI Overheating Mystery / Poss Bleed Hose?
Replies
2
Views
486
D1Nut
D1Nut
B
Discovery Sport Need some advice please
Replies
3
Views
841
lightning
lightning
Back
Top