Devlin
New Member
- Posts
- 201
- Location
- Isle of Arran
My haynes manual gives pump timing in mm lift I am not familiar with this where can I get pump timing in BTDC at engine check speeds in degrees and RPM
Dev
Dev
Pump timing in 0'
- Thread starter Devlin
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
what engine ,what are you trying to do 200 and 300 tdi pumps are preset and use pin and slot in pulley and pump at tdc
Devlin
New Member
- Posts
- 201
- Location
- Isle of Arran
Sorry 300TDi I want to check that the injection timing is advancing and retarding as it should I intend to get a pulse pick up strobe but I need to mark off the pully in degrees BTDC once I can establish this I can get a machine shop to do this for me, satic timing I can do ok but I have flat spot a mile wide below 2000 rpm and really have rev it on hills
Dev
Dev
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
its easier to get it checked in a shop theyd do timing advance and fueling at same time £100 ish , i would check timing, cam and pump then advance pump as far below knock as possible
Devlin
New Member
- Posts
- 201
- Location
- Isle of Arran
Hi thanks, I may well phone a few places
Dev
Dev
Similar threads
