Pump timing in 0'

Devlin · Sep 14, 2011

My haynes manual gives pump timing in mm lift I am not familiar with this where can I get pump timing in BTDC at engine check speeds in degrees and RPM
Dev

jamesmartin · Sep 14, 2011

what engine ,what are you trying to do 200 and 300 tdi pumps are preset and use pin and slot in pulley and pump at tdc

Devlin · Sep 14, 2011

Sorry 300TDi I want to check that the injection timing is advancing and retarding as it should I intend to get a pulse pick up strobe but I need to mark off the pully in degrees BTDC once I can establish this I can get a machine shop to do this for me, satic timing I can do ok but I have flat spot a mile wide below 2000 rpm and really have rev it on hills
Dev

jamesmartin · Sep 14, 2011

its easier to get it checked in a shop theyd do timing advance and fueling at same time £100 ish , i would check timing, cam and pump then advance pump as far below knock as possible

Devlin · Sep 14, 2011

Hi thanks, I may well phone a few places
Dev

Pump timing in 0'

Devlin

New Member

jamesmartin

Well-Known Member

Devlin

New Member

jamesmartin

Well-Known Member

Devlin

New Member

Similar threads