problem with my new p38 help please

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
F

fsteward

New Member
Posts
9
hi i have just got my p38 2.5td today on a m reg
playing a round inside it today and i pressed the hi lo switch (what a mistake):mad:
any way now when i put it in gear it says select neutral
do that and nothing happens press the swicth again and it says hi put it in gear and it says select neutral again drive it and its flat out around 15 mph how can i get it back to normal help please :doh:
 
back

here you can see a cot out of it all

and if there is no blown fuse !! tken i woult taje alppk at number 7 or 2 or 3...

hope this helps
 

Attachments

  • reduktions kasse 1.JPG
    reduktions kasse 1.JPG
    44.7 KB · Views: 323
  • reduktions kasse 2.JPG
    reduktions kasse 2.JPG
    35.5 KB · Views: 199
Is there any way i can run a live and earth to the tc motor so i can put it back to hi mode just as a temp thing as i need to get it home as its on a friends drive at the mo if so what wires go where
 
hi mate thanks for the reply but i have tryed this loads of times but i will say on the dash high but when i put it in gear it says select nutral ill pull away and its still stuck in low flat out around 20mph in 5th
 
sounds like motor needs replacing on rear of t/box,you can remove it ,and tie it out of the way ,you will see triangle shapedc shaft poking out of t/box turn it until you get hi ,turn fully one way low ,turn back a bit neutral a bit further hi cant remember which direction is which,then replace motor later
 
You must log in or register to reply here.

Similar threads

P
P38
Replies
2
Views
787
brianp38dse
brianp38dse
kermit_rr
L322 ZF8HP70 gearbox problem
2 3 4
Replies
77
Views
3K
Datatek
Datatek
B
P38 auto gearbox problem.
Replies
9
Views
446
Datatek
Datatek
G
P38 4.0 v8 Automatic goes into low range all on its own
Replies
9
Views
1K
Datatek
Datatek
F
P38 DSE loss of power when driving
2
Replies
34
Views
2K
Tibo W
T
Back
Top