everett048
New Member
- Posts
- 50
- Location
- salisbury
Hi does any one know the rivnut size or (od) for the side steps on a p38.
thanks.
thanks.
P38 Side steps
- Thread starter everett048
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 83,235
- Location
- Embasinga stocæ
the same as the bolt you are using 
everett048
New Member
- Posts
- 50
- Location
- salisbury
Very good but no! hole in chassis seems to be about 12.5mm in diameter
cheers
cheers
- Posts
- 58,170
- Location
- Preston Lancs.
If they are 8mm rivnuts it will be. Don't fit side steps anyway they look **** on a P38.
Last edited:
Alan C
Active Member
- Posts
- 263
- Location
- Hatfield, Hertfordshire, UK
Search on this site, it's been covered before. Essentially, only the originally supplied rivnuts will work, nothing else. Been there, tried it, failed, fell out. I did find some on the flea bay, they weren't cheap, but did the job. None available at the mo. I don't know what the aftermarket manufactures side steps use. Else drill a big enough hole in the bottom of the chassis to fiddle a nut up inside
