I have original radio with code but having just finished fitting new battery the radio will not accept code. It is lit up code but when I press button 1 to input first number of code nothing happens code just stays on the display . Anyone got any ideas , thanks Paul
P38 radio code input
- Thread starter Paul vice
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Where did you get the radio and code from, was it always yours? or someone sold/gave it to you? and.... its a land rover why did you expect it to work???
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
- Posts
- 3,944
- Location
- Near Heathrow.
Depends on what head unit is fitted. If it's like this, then nothing appears in the display until you press the Up-Down buttons, after pressing number one first.
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
I stand corrected Pete,mine you just have the enter code message,put the code in and hey presto,bleeding eardrums.
HK have a lot to answer for.Code was on my original paperwork and I have used it many times over the years
- Posts
- 4,665
- Location
- Rotherham
I must be lucky mine works fine without code after having battery disconnected
Ok so you know for 100% that its the correct code (that was my point)
Yes that is the exact head unit , but when I press 1 it still says code and if I try to input numbers nothing happens. This has never happened before , normally I press 1 then using up and down buttons select code , then 1 again and so on . But it is not letting me .
dubbleRR
Well-Known Member
- Posts
- 1,018
- Location
- highlands of Scotland
try unplugging it and reconnecting it ....
....Similar threads
