Datatek
Well-Known Member
- Posts
- 45,923
- Location
- Near Poitiers SW France
See pwood999's post.
Last edited:
P38 new problem with abs and traction fault
- Thread starter maxderby
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 4,361
- Location
- Near Heathrow.
@MontyChambers did you do the Nanocom check (not while driving) on the two inputs ? No point in replacing the switch unless you're sure it's broke !!
The RAVE procedure had a missing bit between 7 & 8. It should be:
7. Extend switch plunger fully.
7a. Hold brake pedal down.
8. Fit switch & then release brake pedal.
That way the pedal sets the plunger correctly when you release the pedal.
The RAVE procedure had a missing bit between 7 & 8. It should be:
7. Extend switch plunger fully.
7a. Hold brake pedal down.
8. Fit switch & then release brake pedal.
That way the pedal sets the plunger correctly when you release the pedal.
Datatek
Well-Known Member
- Posts
- 45,923
- Location
- Near Poitiers SW France
Ah good, you have corrected me.
- Posts
- 36,782
- Location
- North Shropshire
If it's already in place then you can pull the plunger out with the pedal down, you don't need to remove it and risk braking it
Pun intended
Pun intended
MontyChambers
Member
- Posts
- 38
- Location
- Blaby
Very helpful, tomorrow mornings job, by the way nanocom is running as it should, Hope for clear sky's tomorrow, metaphorically as well as weather-wise!
