p38 dhse 2.5 won't start

Hi all I'm pulling my hair out with my p38 i purchased it with out it running with a suspected fuel plmp fault (high pressure pump) I tyred the solinoid on the top of the up as it did not click when I wired i directly wired to the positive terminal so i replace d with new one checked and all working fine but still did not gain fuel to the injectors at this point I decided to go all out and buy a pump after fitting I cracked off the injector pipes and turned over but nothing no fuel no bang nothing so I decided to pull the braided pipe of the first injector band it poured fuel out but non to the injectors are recivin fuel iv checked all I know but I'm out of ideas all help would be much appreciated as is doing my head in it also is facing up traction fault and engine disabled press fob to activate so I press key and it starts turning over again

It is more than likely out of sync. ECM security code has been lost from BECM. You will need diagnostics to reset it.

What system would they need to re sync it

brackan said:

What system would they need to re sync it

Click to expand...

A Syncmate for the diesel or a Nanocom for the diesel.

Just got a friend to come up with his fancy computer and it's reading that the engine in immobilised where may the problem lie with this ?

brackan said:

Just got a friend to come up with his fancy computer and it's reading that the engine in immobilised where may the problem lie with this ?

Click to expand...

If you have a dash message "Engine disabled" then it should NOT turn over. If it is turning over but not starting it is out of sync. And needs the security code in the ECM reading and writing into the BECM. Or you can spin it til new year and it will not start. Because without a matching code the ECM is switched off.

The the computer brung up engine immobilised the dash is not saying anything and what system would I need for this cheep as posable

brackan said:

The the computer brung up engine immobilised the dash is not saying anything and what system would I need for this cheep as posable

Click to expand...

It is out of sync then as i said. You will need to use a diesel Syncmate or a diesel Nanocom to resync it. Look on the LZ map and see if there is anyone near you who can help. Unless you can borrow one or get someone to come and do it this is as good as it gets. http://www.ebay.co.uk/itm/BeCM-Sync...hash=item5afa47d9bd:m:mrFhObonpv9SnOxmOY9Q2GA

Sorry iv new to this forum and do not know to you it correctly could you talk me threw

brackan said:

Sorry iv new to this forum and do not know to you it correctly could you talk me threw

Click to expand...

Have had a look nobody near you with diag. You could go on LZ international rescue section and ask for assistance.