P38 abs sensors ( 2001 4.0L ).

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
N

Neil.ms

Member
Posts
48
Location
Goring on Thames
Any recommendations for abs sensors ( front and rear ), prices seem to range from £30 to £400? Have just replaced rear brake lines and after a test drive now have traction failure and abs lights on. Nanocom says rear sensor electrical failure rear right and sensor voltage page says no voltage on the rear left. Am I correct in thinking that the nanocom sometimes gives conflicting results regarding position of failed sensors ( or is it me having a senior moment?). When the rain has stopped I will check the resistance across the sensors to find out where the issue lies.
 
Wait for the rain and take physical measurements of each sensor as you say. This will confirm the Nanos findings. As for price get the best you can and only replace what you need to.
Buy from a known shop and not an eBay special.... ;)
 
Neil.ms said:
Am I correct in thinking that the nanocom sometimes gives conflicting results regarding position of failed sensors ( or is it me having a senior moment?).
Click to expand...
That Nanocom issue has been resolved with a firmware update for over several years now.
Update your firmware to the most recent version.
 
Had some time to get some readings and each of the abs sensors are reading about 980 ohms. Have checked voltage to each sensor and each one is registering 5v. Have just checked continuity from the sensor plug to the connector that plugs into the abs ecu and the readings are all constant at 1.3 ohms. However if the nanocom schematic is correct pin 1 and 5 appear to be the wrong way around? Should I swap the pins around in the plug? Any ideas gratefully received
 

Attachments

  • 3C68328E-13FF-4B5F-8F56-80B70E769E37.jpeg
    3C68328E-13FF-4B5F-8F56-80B70E769E37.jpeg
    130.2 KB · Views: 107
Neil.ms said:
Had some time to get some readings and each of the abs sensors are reading about 980 ohms. Have checked voltage to each sensor and each one is registering 5v. Have just checked continuity from the sensor plug to the connector that plugs into the abs ecu and the readings are all constant at 1.3 ohms. However if the nanocom schematic is correct pin 1 and 5 appear to be the wrong way around? Should I swap the pins around in the plug? Any ideas gratefully received
Click to expand...
Nanocom is probably wrong, there was a known problem which was fixed with a firmware update.
Pins do not swap themselves, so unless someone has interfered with the connector, the pins will be in the correct place and should not be changed.
 
I'm wondering if you have an intermittently failing sensor like I've had? My voltages were all correct but nanocom said no voltage on the right rear but 5 vdc were present.
My abs and tc lights were initially intermittent and now permently on, traced to an open circuit on the os rear. Your abs sensor might be in-between working(when you test them) and finally failing when you're not testing. Long shot/ clutching straws.
 
Thanks for that Flossie. Electrical diagnostics aren’t really my thang? So any ideas are gratefully recieved! Saturday afternoons are my allotted p38 time so as soon as the working week is over I will get the multimeter out and swap some sensors over to see if the fault moves around.
 
Managed to spend some time on the p38 today. Found an old ABS ecu in my treasure trove of stripped parts from a donor vehicle. Swapped it over and all faults gone. Haven’t managed to take it for a test drive yet as there is 5 tonnes of driveway gravel in front of it ( job for tomorrow )!
 
Neil.ms said:
Managed to spend some time on the p38 today. Found an old ABS ecu in my treasure trove of stripped parts from a donor vehicle. Swapped it over and all faults gone. Haven’t managed to take it for a test drive yet as there is 5 tonnes of driveway gravel in front of it ( job for tomorrow )!
Click to expand...
ah put it in low range and drive over the gravel lol
 
You must log in or register to reply here.

Similar threads

kricktd5
L332 abs/ HDC
Replies
1
Views
872
Datatek
Datatek
F
Disco 2 Weird rear abs sensors
Replies
15
Views
1K
sierrafery
sierrafery
B
ABS Issue
Replies
14
Views
967
Bangerang1
B
N
P38 abs / traction fault.
Replies
4
Views
1K
Neil.ms
N
R
4 Amigos ABS Discovery 2 TD5
Replies
5
Views
2K
sierrafery
sierrafery
Back
Top