P38 (-97 4.6) minimum brake disc thickness?

Does anyone know the minimum brake disc thicknesses for the P38?

I have looked in RAVE and spent quite a lot of time fruitlessly googling to no avail, would be very grateful.

I am just about to fit a set of new brakepads but don't want to waste them and the effort by realizing the discs are too worn.

Have a look at this Minimum Thickness

You wont ruin your pads anyway, just swap them over when you fit your ne dsks

I have now had a look at the car and rear were 8 mm and rather uneven, while front was 21 mm and less uneven.

Minimum front thickness per this page EBC / Front Standard Discs / Landrover Range Rover 4.6, 95>2002 / Euro Performance Car Parts appears to be 23 mm and rear per this one EBC / Rear Standard Discs / Landrover Range Rover 4.6, 95>2002 / Euro Performance Car Parts appears to be 10 mm.

So according to this it is clear that my discs are worn well beyond safe limits, also as at least the rears were very uneven it would have, if not destroyed the new pads had I fitted them, certianly not been beneficial.

Not a Bank Breaker-you can get new discs cheap enough from MM 4x4 or paddocks

I have had several years of great experience with EBC Brakes and quite a few not so great experiences with some well known brands, so thanks for the tip but I stick with EBC Brakes for both the discs and the kevlar pads. I expect no judder, good "bite" and almsot zero dust - all this for a decent price.

Spec. shows the following:
Front Disc thickness 25mm (1") Minimum 22mm (0.87") Max. run out 0.15mm (.006")

Rear Disc thickness 12.6mm (0.5") Minimum 11.7mm (.46") Run out 0.15
(.006")

=> Irishrover

Many thanks for that, much apprecited.