hi all i am new to the range rover thing i have just got my self a 98 4.0 se and when its cold it will not pick up properly when you put your foot down it feals like it is miss fireing but when its warm every thing is fine also when its been cruseing on motorway the rev counter starts to jump and it will only do about 90 mph i have changed all plugs leads filters dont know what else to do thanks
p38 4.0 help
- Thread starter steveo17
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
the hooded claw
Well-Known Member
- Posts
- 1,743
- Location
- Fleetwood Lancs, Besides the Sea!!!
Steveo Check the Crank Position Sensor for "Gunge" (or better still just replace it) ...
You got any "Fault Messages" poppin up ?????
You got any "Fault Messages" poppin up ?????
the hooded claw
Well-Known Member
- Posts
- 1,743
- Location
- Fleetwood Lancs, Besides the Sea!!!
Its a Little electrical Connection fitted to /near the pulley (its tells the Ignition system when to fire the plugs & in the right order (sort of) its fitted at the front near the water pump assembly
Looks like this >>>>>>>>
Looks like this >>>>>>>>
dove
Active Member
- Posts
- 393
- Location
- Fife,scotland
the crank sensor is at the rear of the block on opposite side from starter in the same place goes into flywheel,you are pointing out where the cam sensor is the previous pic is the crank sensor
crossa
New Member
- Posts
- 262
- Location
- Newcastle-Upon-Tyne
Welcome is your P38 LPG'd ?
the hooded claw
Well-Known Member
- Posts
- 1,743
- Location
- Fleetwood Lancs, Besides the Sea!!!
Still sounds like the Crank Sensor to me !!!
Similar threads
Freelander 2 (LR2)
Intermittent engine fault
